- AWS D10.10/D10.10M:2021
- Abstract
- Statement on the Use of American Welding Society Standards
- Personnel
- Foreword
- Table of Contents
- List of Tables
- List of Figures
- 1. General Requirements
- 2. Normative References
- 3. Terms and Definitions
- 4. Introduction
- 5. Purposes for Local Heating
- 6. Local 360-Degree Band Heating
- 7. Local Spot PWHT
- 8. Measurement of Temperature
- 9. Insulation
- 10. Other Considerations
- 11. Thermal Cycle
- 12. Response to Deviations
- 13. Considerations Related to Service Environment
- 14. Quality Assurance System
- 15. Induction Heating
- 16. Electric Resistance Heating
- 17. Flame Heating
- 18. Gas-Flame Generated Infrared Heating
- 19. Radiant Heating by Quartz Lamps
- 20. Comparison of Heating Processes
- Annex A (Informative)—List of References
- Annex B (Informative)—Discussion of Issues and Recommendations Regarding the Heated Band
- Annex C (Informative)—Discussion of Stresses Induced During Local 360-Degree Band PWHT
- Annex D (Informative)—Procedure for Thermocouple Attachment by Capacitor Discharge Welding
- Annex E (Informative)—Accuracy of Thermocouple Temperature Measurements
- Annex F (Informative)Information on Types of Insulation
- Annex G (Informative)Standard Procedure for Local Heating
- Annex H (Informative)Standard Documentation Checklist for Local Heating
- Annex I (Informative)Informative References
- Annex J (Informative)—Requesting an Official Interpretation on an AWS Standard
- List of AWS Documents on Piping and Tubing [Go to Page]